The only Infrared gas imaging camera certified and classified for Hazardous Locations:

ATEX, UL, ANSI & CSA
Utilizing certified equipment for use in hazardous location allows a higher level of safety and operability confidence. It increases operator’s efficiency as it eliminates the need for getting a “hot permit” before entering the inspection area.

EyeCGas Certifications:

Hazardous Locations UL1604 – Electrical Equipment for Use in Class I and II, Division 2, and Class III (Classified) Locations. Third edition.
CSA C22.2 No. 213-M1987 – Non-Incendive Electrical Equipment for Use in Class I, Division 2 Hazardous Locations. First edition.
ANSI/ISA-12.12.01 – Non-incendive Electrical Equipment for Use in Class I and II, Division 2, and Class III Hazardous (Classified) Locations. 2011 edition.
ATEX II 3G Ex nL IIC T6 –
EN600079-0 Electrical apparatus for explosive gas atmospheres – Part 0: General requirements.
EN60079-15 Electrical apparatus for explosive gas atmospheres – Part 15: Construction, test and marketing of type protection “n” electrical apparatus.
Encapsulation IP65-Blowing Dust test – MIL-STD-810F, Method 510.4, Procedure I
IP65 – Jetting Water
Vibration 2.4 GRMS Random Vibration – Mil Std 810F 514.5
Temperature and Humidity IEC 60068-2-30 Temp. +25°C / +40°C Humidity 95% RH 3 Cycles of 24 Hours (12+12h cycle).
EMC EN 610000-6-4 : 2007 class A – Radiated Emissions
EN 610000-6-2 :2005 class A – Immunity to Electrostatic Discharge (ESD)
EN 610000-6-2: 2005 class A Radiated Immunity to Power Frequency magnetic field
FCC 47 CFR part 15 subpart B -Radiated Emissions
EN 610000-6-2 :2005 class A Radiated Immunity to RFE
EN60950-1:2006
HALT – High Accelerated Life Test 20 GRMS Vibration level, 8 temp cycles for 4 hours, 60˚C/min temp change rate.
Max temp : 55˚C, Min temp : -20˚C
Certification Data when packed inside the carrying case
Bump ASTM-D 4169-06 Schedule A – Packed. Drop Height 61 cm.
1 drop on each face. Total Drops 6
Loose cargo vibration Test ASTM-D 4169-08 Schedule F Test method D999
Vibration ASTM-D 4169-08 Schedule E Test Method D4728 – 0.73 GRMS 1 hr each of three axes